Toa N-8000 Series - Manual (Page 128)

2-17
Chapter 2 FUNCTIONS AND OPERATION
MASTER STATION'S FUNCTIONS AND OPERATION
2.6. Automatic Transfer
Note
Calls cannot be automatically transferred to the station connected via the multi interface unit.
2.6.1. Group hunting
Calls to a busy station set for Group hunting are automatically transferred to another designated station.
This Group hunting function also applies to the call transfer ( p. 2-15 ) performed during conversation.
Note
The station to which a call is to be transferred can be set either by dialing operation (see p. 2-18 ) or using the
supplied N-8000 Setting Software. (Refer to p. 5-65 , 5-80 .)
Use the supplied N-8000 Setting Software to enable or disable the Group hunting function. (Refer to p. 5-35 ,
5-62 .)
The station to which a call is to be transferred cannot be designated unless the group hunting function is
enabled.
(Example: A call to the station number 62 will automatically be transferred, if No. 62 is busy, to the next
designated station, No. 63.)
Call
No. 11
No. 62
No. 63
No. 10
Conversation
6 2
Notes
Calls are not transferred under the following conditions.
• The designated station is set for Call forwarding.
• The designated station is not in standby mode. (However, even when the designated station is busy, if it is set
for Group hunting, the call is further transferred to the next designated station.)
• The station set for Group hunting is called as a representative or its associated member station of the group.
• The designated station is busy when the system is set to "Selective Response."
• The designated station is the Remote microphone station placed in Privacy mode.