Toa N-8000 Series - Manual (Page 44)

1-27
Chapter 1 GENERAL DESCRIPTION
Figure of the terminal
where protection cover
is removed
Figure viewed from front center
16
17
18
14 15
Protection cover
13
[Rear]
13. Line connection cable [LINE]
Connects to the exchange. (3 m-length cable with
RJ-11 modular plug)
Note: Do not remove the protection cover.
14. External speaker terminal [EXT.SP.]
An external speaker (8 Ω, 0.6 W) can be
connected to this terminal. When connecting,
replace a protection cap with a supplied rubber
bushing. (Refer to p. 3-57 .)
Shift the Speaker selector switch (16) located
on the bottom surface of the unit to the EXT.SP
position when using the external speaker.
15. Contact output terminal [CONTACT OuT]
Permits connection of a device to indicate the
calling station.
This terminal closes only while a call is being
made or received. (Output capacity: 30 V DC and
50 mA.)
When connecting, replace a protection cap with a
supplied rubber bushing. (Refer to p. 3-57 .)
16. Speaker selector switch [INT.SP/EXT.SP]
The internal switch is exposed if the protection
cover is removed.
Used to select either an internal (INT.SP) or an
external (EXT.SP) speaker. After shifting the
selector switch, fit the protection cover back into
place.
17. Microphone
Used for hands-free conversation.
Note
Avoid placing obstacles close to the microphone
that might block sound and prevent conversations.
18. Wall bracket mounting slots
Hang the mounting bracket hooks to these slots
when using the YC-280 Wall mounting bracket.
(Refer to p. 3-19 , p. 3-23 .)
[Bottom]