P. 2-19 – Toa N-8000 Series User Manual
Page 130
2-19
Chapter 2
FUNCTIONS AND OPERATION
MASTER STATION'S FUNCTIONS AND OPERATION
2.6.2. Absence transfer
When no response is made to a call to the station set for Absence transfer for a set period of time, the call is
automatically transferred to another designated station.
Calls received during conversations can be transferred. (Refer to
The station to which a Absence transfer is to be transferred can be set either by dialing operation (see below)
or using the supplied N-8000 Setting Software. (Refer to
,
Use the supplied N-8000 Setting Software to enable or disable the Absence transfer or to set a calling duration.
(Refer to
.)
The station to which a call is to be transferred cannot be designated unless the Absence transfer function is
enabled.
Notes
Calls are not transferred under the following conditions,
• The designated station is set for Call forwarding.
• The designated station is not in standby mode.
• The station set for Absence transfer is called as a representative or its associated member station of the
group.
• The designated station is the Remote microphone station placed in Privacy mode.
Call
A call is automatically
transferred to another
designated station after
a set period of time
Call tone
No. 62
No. 11
Call tone
The designated transfer
destination station
No. 63
6
2
Programming or erasure can be performed at your station.
[Programming]
4
4
X
X
+
+
+
(Confirmation tone)
Function designation
number
Transfer destination
station number
[Erasure]
4
4
Y
Y
+
+
+
(Confirmation tone)
The originally called (your) station number
Notes
• The station to which a call is to be transferred via multi interface unit cannot be programmed as a
transfer destination station.
• The programmed contents set by dialing operation are automatically saved into the exchange or IP
stations at midnight every day. If the exchange or IP station is turned off before completion of save, the
state returns to the contents that were programmed before power-off.