Toa N-8000 Series - Manual (Page 426)

Chapter 5 SYSTEM SETTINGS BY SOFTWARE
5-16
4.2. Changing Equipment Settings
4.2.1. Single Unit Selection and Activation
Select the device to be changed on the Equipment IP Setting screen, then click "Change IP Settings" button.
The following screen shows an example in which a single device is activated after it has been selected on the
Equipment IP Setting screen.
(1) Ip Address
Set the device’s IP address.
(2) Subnet Mask
Set the device’s subnet mask.
Click on the "Validate subnet mask edit" checkbox
to change settings.
(3) Default Gateway
Set the device’s default gateway.
Click on the "Validate default gateway edit"
checkbox to change settings.
(4) Enable Subnet Mask Configuration
Selects whether to enable or disable subnet mask
changes.
(5) Enable Default Gateway Configuration
Selects whether to enable or disable default
gateway changes.
(6) Web port
Set the web server port number.
(7) Name
Set the name of the device.
(1) Ip Address
Set the starting value of the IP address to be
assigned to the selected devices.
(2) Subnet Mask
Set the subnet mask to be assigned to the
selected devices.
(3) Number of Assigned Units
Set the number of devices for which the same
IP address is to be assigned from the starting
IP address number. The IP addresses for the
designated number of devices is assigned in
sequential order from the IP address set in "(1) IP
Address."
4.2.2. Multiple Unit Selection and Activation
Select the device to be changed on the Equipment IP Setting screen, then click "Change IP Settings" button.
The following screen shows an example in which a single device is activated after it has been selected on the
Equipment IP Setting screen.