Toa N-8000 Series - Manual (Page 433)

Chapter 5 SYSTEM SETTINGS BY SOFTWARE
General: Station Table
5-23
Pressing the Collective setup button permits station types, station numbers, and station names for all or
selected stations to be set all at once.
Step 1. Press the Collective Setup button.
The Collective setup window appears.
Step 2. Select either "All stations" or "Selected stations" for the Setup range.
When "Selected stations" is selected, designate the setup range on the Station Table screen.
To do so, drug the mouse over the station list, or click stations one by one while holding down the Shift
key of the PC.
Step 3. To change the type of station connected to the exchange, tick the "Change station type" box and select
desired type from the pull-down menu.
Note: Types of IP stations cannot be set collectively.
Step 4. To change the type of station connected to the Substation interface unit, tick the "Change sub-station/
station type" box and select desired type from the pull-down menu.
Step 5. To assign sequence station number, tick the corresponding box and enter the start number.
Example: When "100" is entered for a start number, the station numbers to be automatically set are
"100," "101," "102," and so on.
If a set station number comes to the maximum number in the set number digits, no further station
number is assigned.
Step 6. To set the station name with sequence number, tick the corresponding box and enter a new name.
Up to eight alphanumeric characters including the sequence number can be used.
Example: When a station name "sta1-" is entered, the station names to be automatically set are "sta1-
1," "sta1-2," "sta1-3," and so on.
Step 7. Press the [OK] button.
(6) Station name
Set the name of each station using up to eight alphanumeric characters. Station names can be displayed
on multifunctional stations.
[Collective setup]
3
2
4
5
6
7
1