Toa N-8000 Series - Manual (Page 473)

Chapter 5 SYSTEM SETTINGS BY SOFTWARE
IP Station: Function Settings 1
5-63
(3) Time limit
Set the time-out value for calling, conversation or paging functions in ten-second units between 10 and 990
seconds.
Call time-out: Set whether to limit the duration of a call to the station. If setting a time-out, enter
the time limit after which calls to the station are automatically terminated. If not
setting a time-out, calls will continue until they are cancelled or the called station
responds.
Conversation time-out: Set whether to limit the duration of conversations with the station. If setting a time-
out, enter the time limit after which conversations to the station are automatically
terminated. If not setting a time-out, conversations will continue until executing the
termination operation.
Paging time-out (IP Master station and IP Remote microphone station only):
Set whether to limit the duration of paging call with the station. If setting a time-
out, enter the time limit after which paging calls to the station are automatically
terminated.
If not setting a time-out, paging calls will continue until executing the termination
operation.
(4) BGM input
Set BGM to be heard at this IP station.
Select the unit's number and audio input number of the Multi interface unit to which the BGM sound sources
are connected.
(5) paging with call tone (Ip Master station and Ip Remote microphone station only)
Sounds a pre-announcement tone when paging is initiated.
(6) Delay Time
Set the delay time before paging is initiated.
(7) paging response mode (Ip Master station and Ip Remote microphone station only)
Select either "Zone Selection" or "Automatic response" modes when responding to the paging.
Zone Selection: Responds to a paging call by designating the number of the paging zone. Respond
to the paging party who made the paging to the designated zone last is called. Use
this mode if paging announcements are heard from multiple zones.
Automatic response: Use only the paging response key to make a response. The responding station
is connected to the station that made a paging call over the paging zone through
which the responding station last received a call.
(8) priority settings (Sequential response mode only)
Sets whether paging calls or conversations should take precedence when these occur simultaneously.
Paging priority: When a call is received while receiving a paging call, the called station becomes
busy and the paging call is gone through. Station keys cannot be used while
receiving a paging call. (Paging response cannot be performed at a paging
receiving station, either.)
Conversation priority: A paging call is not received when paged during a conversation or dialing operation.
Station keys can be dialed even while receiving a paging call.