Toa N-8000 Series - Manual (Page 88)

1-71
Chapter 1 GENERAL DESCRIPTION
Function Description
Reference page
Operation Setting
Call Transfer
Current conversations can be placed on hold to
call a third party by pressing the Transfer key. The
original conversation can be subsequently restored
or transferred to the third party after conclusion of the
second call.
p. 2-15
Automatic
transfer
Group hunting
Calls to a busy station are automatically transferred to
another designated station, if group hunting function is
set to the called station.
p. 2-17
p. 5-62
p. 5-65
Absence transfer
When no response is made to a call for a set period
of time, the call is automatically transferred to another
designated station.
p. 2-19
Call forwarding
Calls to stations are automatically transferred to
another designated station without sounding a call tone.
Programming a station to which a call is to be rerouted
instantly sets that station to the Call forwarding mode.
p. 2-20
Time-based call
forwarding
Calls to stations are automatically transferred to
another designated station without sounding a call
tone. Even when the station to which a call is being
rerouted is programmed, the station is not switched to
Call forwarding mode until the set time is reached.
p. 2-21
Remote response
Calls to a station can be answered by pressing the
Push-to-talk key of another station, provided both
stations are assigned to the same group.
p. 2-22 p. 5-125
Executive priority
If a called station is busy, as indicated by a busy tone,
pressing the [9] key transmits a short priority call tone,
then forcibly terminates the current conversation,
allowing the call to go through. Access to priority
call operation or refusal of priority calls can be set
individually for each station.
p. 2-24 p. 5-67
Station speaker volume setting
Pressing the [#/ ] key during conversation increases
the volume.
Pressing the [ / ] key during conversation decreases
the volume.
p. 2-98 p. 5-65
Microphone indicator
The broadcast status indicator on the left side of the Talk
key can be switched to act as a microphone indicator.
p. 2-115