Toa N-8000 Series - Manual (Page 230)

2-119
Chapter 2 FUNCTIONS AND OPERATION
DOOR STATION'S FUNCTIONS AND OPERATION
2. MAKING AN EMERGENCY CALL
(only possible when system is set for "Selective Response")
Emergency Calls take precedence over other calls. If the Master Station or telephone responds to the Emergency
Call, the conversation becomes an Emergency Conversation and is handled with a higher priority than other
conversations and paging calls.
Notes
• Only Door Stations that are set to be capable of making an Emergency Call when the system response mode
is set to "Selective Response" can initiate the Emergency call.
• If the Master Station or telephone responds to an Emergency Call when all speech links are occupied, a
lower-priority conversation or paging call will be interrupted for the Emergency Conversation to begin.
Step 1. Press the call button twice or more in rapid succession (under 400 ms interval).
If a Master Station is called, the Emergency Call tone is sounded.
If a Multi-Functional Master Station is called, the Emergency Call indication is
displayed and the Emergency Call tone sounded.
Note
Call time limits are not applicable to the Emergency Call.
Step 2. Begin the conversation if the called station responds. (Emergency Conversation)
The conversation can continue until terminated by the called master station or telephone.
Note
Call time limits are not applicable to the Emergency Conversation.
Notes
• Preprogram the master station or the telephone to call to.
Programming can be performed by dialing operation of the multifunctional master station (refer to p. 7-9 ) or
using the supplied N-8000 Setting Software (refer to p. 5-68 , 5-83 ).
• Door Stations must be set to allow Emergency Call.
• Use the N-8000 Setting Software to enable or disable Emergency Call operation for the Door Station.
(Refer to p. 5-67 , 5-82 .)
• Use the N-8000 Setting Software to set the system's response mode. (Refer to p. 5-26 .)
3. RECEIVING A CALL
Step 1. When receiving a call from the master station, the
call tone sounds only once, after which the calling
party's voice is heard immediately through the
internal speaker.
Step 2. Answer by speaking into the door station.
Step 3. Conversation is terminated if the called party replaces the handset or presses the Clear key.
Note
Conversation termination operation cannot be executed at the door station.
Conversation can be terminated by the termination operation at the master station or telephone, or
after the preset time limit.
Call tone (once) Voice