Toa N-8000 Series - Manual (Page 331)

3-27
Chapter 3 INSTALLATION & WIRING
[N-8033MS]
Attach the N-8033MS to the YC-841 Wall-mount box or an electrical box installed in a wall.
N-8033MS
YC-841 or electrical box
YC-841 bottom
Acoustic material ( supplied with the N-8033MS )
Note
Lay it down along the inside of the box.
Machine screw M4 x 35
(supplied with the N-8033MS)
Wall surface
Knockout holes
Note
After installing the N-8033MS,
check first if the conversations
can be made, then attach the
both ends of the adhesive sheet
to the N-8033MS’s front surface
by removing exfoliate paper
provided at these ends.
Remove either of the 2 knockout
holes in the bottom so that it can
work as a weep hole (to allow
water to exit), and secure the
YC-841 to a wall.
Seal the panel edges.
Note
When installing the N-8033MS outdoors or at locations
where it gets wet with water, tightly seal the panel edges.
For sealing method, consult your TOA dealer.
254 236
9
70
115
[Installation completion drawing]
Unit: mm