Toa N-8000 Series - Manual (Page 188)

2-77
Chapter 2 FUNCTIONS AND OPERATION
MASTER STATION'S FUNCTIONS AND OPERATION
Step 2. Message Paging Termination
There are two termination methods.
2-1. Termination by IP Master Station key.
Press the Clear key.
Note
This operation forcibly terminates the Message Paging even if the number of
broadcast repetitions is set.
2-2. Termination by Preset Repetitions
The broadcast automatically terminates when the message is played back the set number of broadcast
repetitions.
Notes
• Use the N-8000 Setting Software to set the number of repetitions. (Refer to p. 5-70 .)
• Even if the paging time has been limited (refer to p. 5-63 ), this has no effect on the Message paging.
• Opening the Standard IP Master Station's Message Activation terminal does not terminate the paging.
To terminate, press the station's Clear key or set the number of paging repetitions.
5.10.2. Message paging priority level
The Message paging takes precedence over normal conversations and paging calls (except Emergency
paging). When the station to which the Message is being transmitted is in operation, all such operations are
forcibly terminated, allowing the Message paging to go through. Such terminated operations are not restored
even after the Message paging is completed.
5.10.3. Contact interlock control
The N-8000MI/8000DI/8000AF unit's contact output terminal can be made to close in synchronization with
the initiation of the Message paging. Two methods are available for this: one is to constantly keep the terminal
closed during message paging and the other is to close the contact by means of a one-shot pulse only when
the broadcast begins.
5.10.4. Programmed message confirmation
Messages programmed into the IP Master Station can be confirmed at that station.
Step 1. When the IP master station is in Standby mode, press the Paging Call
key, followed by the Paging Response key.
The Message can be heard from the internal speaker or handset of the
operated station.
Step 2. Press the Clear key.
Message playback completed.
Note
The message is repeatedly played back until the Clear key is pressed.
5.10.5 Muting Message pagings (N-8510MS only)
Only the master station (N-8510MS only) activating Message pagings can be set not to output Message pagings
from its station speaker.
Other operations such as status indicator lighting, repetition of paging, and contact-related controls except
Message paging output are the same as those when mute is not activated.
Audio signals are output as normal at the paging receiving stations.
When the operation other than Message paging activation is performed, sound source (like a call tone)
corresponding to the operation is output.
Tip: Use the supplied N-8000 Setting Software for Message paging mute setting. (See
p. 5-70 .)
Notes
• The IP Remote Microphone Station cannot be set to mute Message pagings.
• Message pagings can be muted at the master station’s built-in speaker only but not at its handset speaker.
• While a Message paging is activated, sound sources such as an error tone other than a message, even if
produced, will be muted. However, these sounds are not muted unless Message pagings are activated.
C
Emergency situation.