Toa N-8000 Series - Manual (Page 273)

2-162
Chapter 2 FUNCTIONS AND OPERATION
OPERATION FROM AN OUTSIDE LINE
2.2. Selectable Paging
Paging calls can be made to up to 50 preprogrammed zones.
Use the supplied N-8000 Setting Software to set the paging zones. (Refer to p. 5-121 .)
Step 1. Lift the handset and dial the N-8000CO's outside line number.
The N-8000CO unit automatically responds to the call and a dial confirmation tone is transmitted to
the caller.
Step 2. After hearing the confirmation tone, press the [ ][8] keys, then [ ] key, followed by the desired paging
zone number (1 − 192).
Note
Enter a zone number with the digit length (1 − 3 digits) set by way of the N-8000 Setting Software.
Step 3. To select the zone numbers consecutively, press the [ ] key.
Step 4. To terminate the zone selection, press the [#] key following the zone number.
A paging tone is sounded in the selected zone(s).
Step 5. Page with the handset.
Note
If the system's paging response mode has been set for Zone number designation response (refer to p.
2-32 .), announce the response zone number (any one of the paged zones) to the paged party in the
paging message.
Step 6. Either replace the handset or press the [0][0][#] keys.
The paging is completed.
Notes
• A repeated busy tone is heard at paged stations if the handset is replaced to terminate paging.
• If paging is terminated by [0][0][#] key operation, the DTMF signal tones of these keys are heard at
paged stations.