P. 5-65 – Toa N-8000 Series User Manual
Page 475
Chapter 5
SYSTEM SETTINGS BY SOFTWARE
IP Station: Function Settings 2
5-65
Step 3. Click "Function Settings 2" tab to display the following setting screen.
Available item differs depending on the type of IP stations.
Step 4. Set individual items.
(1) Incoming call mode
Call receiving mode (
) can be selected either "Automatic connection" or "Continuous call". Call with
a call tone or without a call tone can be set on both modes.
The IP door station is fixed to "Automatic connection" mode.
(2) level
Microphone sensitivity: Station hands-free microphone sensitivity can be adjusted in three increments
from 1 (minimum) to 3 (maximum). The default sensitivity is Level 2.
Speaker output:
Station speaker output level can be adjusted in five increments from 1 (minimum)
to 5 (maximum). The default sensitivity is Level 3.
Call volume:
Station call volume can be adjusted in five increments from 1 (minimum) to 5
(maximum). The default sensitivity is Level 3.
(3) Group call (max. 15) (Ip Master station and Ip Remote microphone station only)
Set a group of up to 15 stations that will be called simultaneously when the IP station being set now is
called. With this setting, even when a called station is busy, any registered station in the group can respond.
(4) Calls transferred to (Ip Master station and Ip Remote microphone station only)
Set the station number to which each transfer is to be directed.
When the C/O interface unit is set as a transfer destination station, enter "#", followed by the access
number. For example, when setting the C/O interface unit with access number "05," enter "#05".
Call forwarding receiving station can be set only when the call forwarding function is enabled. (Refer to
Note
The station to be called via Multi interface unit cannot be programmed as a transfer destination station.