Toa N-8000 Series - Manual (Page 446)

Chapter 5 SYSTEM SETTINGS BY SOFTWARE
Exchange: Function Settings
5-36
(3) Time limit
Set the time-out value for calling, conversation or paging functions in ten-second units between 10 and 990
seconds.
Call time-out: Set whether to limit the duration of a call to the station. If setting a time-out,
enter the time limit after which calls to the station are automatically terminated.
If not setting a time-out, calls will continue until they are cancelled or the called
station responds.
Conversation time-out: Set whether to limit the duration of conversations with the station. If setting
a time-out, enter the time limit after which conversations to the station are
automatically terminated. If not setting a time-out, conversations will continue
until executing the termination operation.
Paging time-out: Set whether to limit the duration of paging call with the station. If setting a time-
out, enter the time limit after which paging calls to the station are automatically
terminated.
If not setting a time-out, paging calls will continue until executing the termination
operation.
(4) BGM input
Set BGM to be heard at the stations connected to the selected exchange.
Select the unit's number and audio input number of the multi interface unit to which the BGM sound sources
are connected.
(5) Audio Trigger
Set the timer interlock and restricted time interval for the N-8050DS unit’s audio trigger. This setting is
possible only when the N-8000EX exchange is used.
Time-based audio trigger: Selecting "Time Interlock ON" allows the time range that enables the audio
trigger to be set.
Audio trigger time-out: Set the operation time limit for the audio trigger monitor.
(6) paging with call tone
Sounds a pre-announcement tone when paging is initiated.
(7) Delay Time
Set the delay time before paging is initiated.
(8) paging response mode
Select either "Zone Selection" or "Automatic response" modes when responding to the paging.
Zone Selection: Responds to a paging call by designating the number of the paging zone. Respond
to the paging party who made the paging to the designated zone last is called. Use
this mode if paging announcements are heard from multiple zones.
Automatic response: Use only the paging response key to make a response. The responding station
is connected to the station that made a paging call over the paging zone through
which the responding station last received a call.
(9) priority settings
Sets whether paging calls or conversations should take precedence when these occur simultaneously.
This function is fixed to "Conversation priority" for the N-8010EX.
Paging priority: When a call is received while receiving a paging call, the called station becomes
busy and the paging call is gone through. Station keys cannot be used while
receiving a paging call. (Paging response cannot be performed at a paging
receiving station, either.)
Conversation priority: A paging call is not received when paged during a conversation or dialing operation.
Station keys can be dialed even while receiving a paging call.