Toa N-8000 Series - Manual (Page 235)

2-124
Chapter 2 FUNCTIONS AND OPERATION
SUBSTATION/SWITCH PANEL'S FUNCTIONS AND OPERATION
Brief call tone
Steady-on
(When the RS-140 is used.)
External speaker
1.2. Operation Using the Call Button
(when the system is set to "Selective Response" mode)
Step 1. Press the call button to call the pre-programmed master station or telephone.
The status indicator flashes (RS-140/180/480 only).
Note
When the call time limit has been set, if no response is made within a set
period of time, the call is automatically terminated.
Step 2. Speak toward the panel when a call tone is
heard. (Speak toward the external speaker in
the case of the RS-140/142/143/144.)
Notes
• The status indicator mode changes from
flashing to steady-on state (RS-140/180/480
only).
• Lifting the handset permits handset
conversation when the RS-141 is combined
with the RS-140/142/143/144, or when the RS-
442/481 is combined with the RS-480.
Step 3. Terminate the conversation.
Conversation is terminated if the called party replaces the handset of the
master station or telephone, or presses the Clear key.
Replacing the handset terminates handset conversation when the RS-141 is
combined with the RS-140/142/143/144, or when the RS-442/481 is combined
with the RS-480.
Note
The status indicator goes out when the conversation terminates (RS-140/180/480 only).
Notes
• The RS-142 has 2 call buttons, and RS-442 has 3 call buttons. When other call button is pressed during calls
made using one call button, these calls currently in progress are cancelled, permitting the later calls to go
through if the call button pressed later has a higher priority than that pressed earlier.
• The RS-144 has the call and Emergency Call buttons. When the Emergency Call button is pressed during
calls made using the call button, these calls currently in progress are cancelled, permitting the emergency
calls to go through.
• Preprogram the master station or the telephone to call to.
Programming can be performed by dialing operation of the multifunctional master station (refer to p. 7-10 ) or
using the supplied N-8000 Setting Software (refer to p. 5-56 ).
• Use the supplied N-8000 Setting Software to perform call time-out function setting. (Refer to p. 5-54 .)
Flashes