Toa N-8000 Series - Manual (Page 193)

2-82
Chapter 2 FUNCTIONS AND OPERATION
MASTER STATION'S FUNCTIONS AND OPERATION
(Access code number: Example when the password is 1234)
(Example when station number is 15)
or
1 2 3 4 1 2 3 4
1 2 : 0 0 A M
1 0 0
or
1 5 1 5
5.13. Access Code Authentication
(except N-8500MS/8510MS)
Usage of the master station can be restricted when the access code authentication is enabled.
Entering a preprogrammed 4-digit access code number before each function key number permits the master
station to be used as usual. Incorrect access code number entry will cause an access error.
Following are restricted functions: Functions to activate at the master station such as calls, paging calls and
scan monitoring, and functions to control through dial operations such as external equipment control and
setting change for the original station.
Call receiving and remote response can be executed without the need for access code number entry.
Emergency paging call activation and Message paging activation functions, which have higher priority, can be
used without entering an access code number.
Operation not in standby mode such as manual call transfer during conversation can be executed without
entering an access code number.
Tip: Use the supplied N-8000 Setting Software for access code authentication and access code number
setting. (See p. 5-66, 5-81 )
Notes
• The N-8500MS Multi-functional IP Master Station, M-8510MS Standard IP Master Station, and stations
at the Tie-line side or PBX side connected to the N-8000MI Multi-interface unit cannot use Access code
authentication function.
• When initiating calls by One-touch dialing or Remote dialing, the access code number is required.
When registering the number, include the access code number before the dial key number to activate function
such as station number.
• When access code authentication is enabled, redial function cannot be used.
• Access code authentication cannot be performed by auto-dialing.
5.13.1. Operation
The steps below show an example of making station call when access code authentication is enabled.
Step 1. Press the access code number
(4-digit number).
In this case, the station's handset
may be either lifted or in place.
Tip
The entered digit of password will be displayed as an asterisk ( ) at
the master station equipped with an LCD screen, then all asterisks
are cleared after a 4-digit input is completed.
Step 2. Press the station number to call.