Toa N-8000 Series - Manual (Page 492)

Chapter 5 SYSTEM SETTINGS BY SOFTWARE
Station: Function Settings
5-82
(13) Trigger (Door station only)
Selects the trigger.
Level: Detects sounds of a sound pressure level higher than the set level that last for a specified
period of time.
Audio: Detects human voices.
Duration (Level): Set the time interval till sounds are detected.
Level: Set the threshold sound pressure level.
Duration (Audio): Set the duration of the human voice’s vowels to detect.
Sensitivity: Sets the detection sensitivity of the human voice.
Setting range: 1 – 9 (9 steps, 1: Most likely to detect, 9: Least likely to detect)
(14) Door station mode (Sequential response mode, Door station only)
Set whether to operate the door station in door station mode*.
* The call tone sounds only once at the door station when the door station calls the pre-programmed master
station. The call timeout and conversation timeout are set to 30 seconds each.
(15) Call Activation - push 3 times (Sequential response mode, Door station only):
Sets whether or not to make a call by the operation of pressing the Call button 3 times within 3 seconds.
(16) Access to priority call operation (Sequential response mode, Master station only)
Enables the station to initiate priority calls.
(17) Refusal of priority call operation (Sequential response mode only)
Enables the station connected to the N-8000EX to refuse priority calls from other stations.
For the station connected to the N-8010EX, this function is fixed to ON (with the checkbox ticked).
(18) Access to emergency call operation (Selective response mode, Door station only)
Sets whether or not to allow the station to make an emergency call.
(19) Access to paging call operation (Master station only)
Enables or disables paging calls from the station.
(20) Access to emergency all paging call operation (Master station only)
Enables or disables emergency all paging calls from the station.
(21) Access to audio trigger setting operation (Master station only)
Enables or disables audio trigger setting from the station.
(22) External equipment control (Master station only)
Set whether the one-shot make output or make/break output is operated at the station.