Toa N-8000 Series - Manual (Page 152)

2-41
Chapter 2 FUNCTIONS AND OPERATION
MASTER STATION'S FUNCTIONS AND OPERATION
X X X
N-8000 zone number
(001 – 192)
4.5.2. Simultaneously activating paging, selected zone broadcast, and control output pattern
Broadcasts to the N-8000 system zone (paging zone or paging zone pattern* 1 ) and the SX-2000 system zone
(individual zone or zone pattern* 2 ), and SX-2000 system's control output activation can be performed at the
same time.
Broadcast durations can be limited by preprogramming the time limit (10 − 990 seconds in 10-second units or
1 − 20 minutes in 1-minute units) for each station.
* 1 A pattern into which multiple paging zones are grouped.
* 2 A pattern into which multiple zones are grouped.
Notes
• Set the N-8000 system zone and time limit (Time out) using the supplied N-8000 Setting Software. (Refer to
p. 5-121, 5-77, 5-63, 5-72 .)
• Perform SX-2000 zone pattern settings using the N-8000 Setting Software. You can also import and use the
output zone pattern having been set on the SX-2000 Setting Software.
Tip
When making N-8000 Paging call and SX-2000 Selected zone broadcast at the same time, the same operations
regarding pre-announcement paging tone, chime tone, or other paging-related functions are performed to both systems.
Determine which setting to choose, N-8000 system setting or SX-2000 system setting by the priority settings
( p. 5-73 ) in the N-8000 Setting software.
The table below shows the operations depending on the priority setting.
Priority setting Operation
N-8000 Operates according to the settings of the N-8000 pre-announcement paging tone,
paging delay time, and paging time limit in addition to the Paging call and Selected
zone broadcast.
A paging pre-announcement tone instead of a chime tone is also broadcast to the SX-
2000 system zone.
SX-2000 Operates according to the settings of the SX-2000 chime tone, waiting time, and time
out in addition to the Paging calls and Selected zone broadcast.
A chime tone instead of a pre-announcement paging tone is also broadcast to the
N-8000 system zone.
It is not possible to operate on each different setting that a pre-announcement paging tone is broadcast to the
N-8000 system and a chime tone to the SX-2000 system.
[Operation]
Step 1. Press the Paging key.
Step 2. Select an N-8000 zone and SX-2000 zone.
Multiple N-8000 zones, N-8000 zone patterns, SX-2000 zones, or SX-2000 zone patterns can be
sequentially selected by repeating the key operation in the following step 2-1 or 2-2.
Note
The maximum number of digits for zone selection dial is 380.
2-1. When selecting an N-8000 zone
Press the following keys in order.
Note
Enter the zone number with the digit length (1 − 3) set on the N-8000 Setting Software.