Toa N-8000 Series - Manual (Page 136)

2-25
Chapter 2 FUNCTIONS AND OPERATION
MASTER STATION'S FUNCTIONS AND OPERATION
3. PAGING FUNCTION AND OPERATION
3.1. Paging
Paging stations are preprogrammed.
Paging durations can be limited by preprogramming the time limit (between 10 and 990 seconds in 10-second
units) for each exchange or IP station.
Note
Use the supplied N-8000 Setting Software to enable or disable the paging operation and to set the paging
duration. (Refer to p. 5-36 , 5-63 , 5-67 , 5-82 .)
3.1.1. Zone paging
Paging calls can be made to one of the pre-programmed zones.
Use the supplied N-8000 Setting Software to set the paging zones. (Refer to p. 5-121 .)
Step 1. Press the Paging key, followed by the desired paging zone number (1 − 192).
A paging tone is transmitted to the selected zone.
Note
Enter a zone number with the digit length (1 − 3 digits) set by way of the N-8000 Setting Software.
Step 2. Page with the handset either lifted or in place.
If the system's paging response mode has been set for Zone number designation response (refer to p.
2-32 ), announce the response zone number to the paged party in the paging message.
Step 3. Either press the Clear key or replace the handset.
The paging is completed.
No. 1001 No. 1002 No. 1003 No. 1004
Zone 23
No. 6000
Zone 192
Amplifier
Speaker
or
0 3 2
C
or
Zone 1
Amplifier
Speakers
(Zone number with 3-digit length)
1
2
3
[Example paging to the zone 23]