Toa N-8000 Series - Manual (Page 480)

Chapter 5 SYSTEM SETTINGS BY SOFTWARE
IP Station: Message Paging
5-70
5.7.5. Message paging settings (Ip Master station and Ip Remote microphone station only)
Step 1. Click "Message Paging" tab to display the following setting screen.
Step 2. Mark the [Operate message paging] checkbox. This allows the following items to be set.
Step 3. Set the [Time-based message paging].
Time-based message paging: Restricts the duration available for the message paging. The message
paging operation can be performed only for the duration between Start
and End time.
Step 4. Set the [Activation method].
Dial operation: Activates the message paging by means of dial operation.
Contact input: Activates the message paging by means of external contact input.
Note: The N-8500MS/8600MS/8610RM IP Master Station cannot activate broadcasts
using the external contact input.
Step 5. Set the broadcast destination.
Set the [Paging zone number] of the broadcast destination.
Step 6. Perform settings for [Repeat].
Repeated during activation: The message is endlessly repeated and broadcast until operation is
terminated.
Restricted No. of times: The message is repeated for the designated number of times from 1 to 10.
Step 7. Set the mute function of the station to operate. (N-8510MS only)
Set whether or not to mute sound to be output from the built-in speaker of the master station that
activates Message pagings.