Toa N-8000 Series - Manual (Page 45)

1-28
Chapter 1 GENERAL DESCRIPTION
2
1
11
3
4
5
9
10
6
7
8
12
6.1.7. N-8031MS Flush-Mount Master Station
1. Status indicator (red)
Flashes when a call is received, continuously lights
during a conversation, and is off while in standby
mode. The indicator also continuously lights while
receiving a paging announcement.
2. Paging key [CALL]
Makes a paging. (Refer to p. 2-25 .)
3. Hold key [HOLD]
Places the conversation on hold. (Refer to p. 2-14 .)
4. Push-to-talk key [PTT]
Pressing this key while calling a party by means
of a continuous call tone permits a voice call to be
made. (Refer to p. 2-9 .) Also, pressing this key
during a hands-free conversation establishes a
one-way conversation from the party who pressed
the key.
(Refer to p. 2-7 .)
5. Speaker
Outputs call tones and used for hands-free
conversations.
6. Paging response key. [RESP.]
Responds to a paging. (Refer to p. 2-31 .)
7. Function key [FUNCTION]
Use this key to perform function settings such as
assigning call transfer recipients or programming
one-touch dialing.
8. Redial key [REDIAL]
Permits the last called number to be dialed. (Refer
to p. 2-8 .)
9. Transfer key [TRANSFER]
Used to transfer the current conversation to
another station. (Refer to p. 2-15 .)
10. Dial keys
Use these keys to make a call or set a function.
11. Clear key [C]
Terminates the conversation.
12. microphone
Used for hands-free conversation.
13. Line connection terminals [1, 2]
Connect to the exchange. (Pin header)
Note
The removable terminal plug (2P) is factory-
attached. (Refer to p. 3-56 .)
7
8
9
C
COM
1 2
13
14
15
[Rear] [Front]