Toa N-8000 Series - Manual (Page 223)

2-112
Chapter 2 FUNCTIONS AND OPERATION
REMOTE MICROPHONE STATION'S FUNCTIONS AND OPERATION
7.5. Multi-Operation Activation
7.5.1. Simultaneously activating selected zone broadcast and control output pattern
When the control output pattern is programmed into the zone selection key, broadcasts to the SX-2000 zone
(zone and zone pattern* 1 ) and SX-2000 control output activation can be made simultaneously. The control
output will be deactivated simultaneously with the completion of Zone broadcast.
Broadcast durations can be limited by preprogramming the time limit (between 1 and 20 minutes in 1-minute
units) for each station. (Only when the Talk key is set to "LOCK")
* A pattern into which multiple zones are grouped.
Note
Use the supplied N-8000 Setting Software for control output pattern* 2 programming, Zone pattern* 2 setting, and
time limit (Time out) setting. (See p. 5-77 , 5-72 .)
* 2 You can also import the control output patterns or output zone pattern settings performed using the SX-2000
Setting Software.
[Operation]
Operations are the same as those of the Selected zone broadcast (see
2-106 ).
Note
Control output activation or deactivation cannot be interlocked with the Selected zone broadcast using the
Control output key.
Pressing the Zone key followed by the Control output key immediately activates only the control output.
(Example)
The figure at right shows an example to make
SX-2000 broadcast to the zones assigned to
the zone broadcast pattern 01 and zone 8 as
well as to activate control output pattern 1.
Zone selection key
(Zone 8)
Zone selection key
(Zone pattern 01: Zones 1, 2, and 3,
and Control output pattern1)
Green Orange
Orange Green
Broadcast status indicator
Microphone indicator
Selection indicator
Status indicator
Talk key
Zone 1
Zone
1 2 3 8
Zone 2
Zone 3
Speaker
Speaker
Zone 8
SX-2000 System
Control output pattern 1 activation
Amplifier
Amplifier