Toa N-8000 Series - Manual (Page 379)

3-75
Chapter 3 INSTALLATION & WIRING
Cable
Ferrite clamp
(supplied with the N-8500MS)
13.12. IP Station Connection
13.12.1. N-8500MS connections
N-8500MS rear
To network
To PC
To AC mains
To external speaker
DC INPUT EXT.SP. HEAD PC LAN
SET 12V 400mA
1
2
3
4 5
To headset
1. AC adapter terminal connection
Connect the AC adapter* 1 .
Install the supplied ferrite clamp on the AC adapter
cable by winding the cable around the ferrite clamp
once.
* 1 Use the AC adapter AD-1210P/1215P (optional)
or the equivalent.
As for the usable adapter, consult your TOA
dealer.
2. external speaker terminal connection
3. headset plug connection
4. Network connection terminal connection
Can be connected to a network of 10BASE-
T/100BASE-TX in auto-sensing.
Connecting the station to a PoE (Power over
Ethernet) switching hub compliant with IEEE802.3af
eliminates the need for an AC adapter. (For
connection, refer to the instruction manual supplied
with the switching hub.)
Use a straight through cable of UTP category 5 or
more for this connection.
5. PC connection terminal connection
A PC can be cascaded with the station. If power
is not supplied to the station, hub function will not
work.
Use a straight through cable of UTP category 5 or
more for this connection.
Note: Be sure to connect one PC only.
* 2 0 dB = 1 V/pa (1 kHz)
INT.
SP
EXT.
SP
Note
When using the external speaker,
set the internal/external speaker
switch on the bottom to the EXT.
SP position.
HOT
Microphone sensitivity: –49 dB* 2
Speaker impedance: 32
COM
COM
HOT
11 mm
Press down the desired push-
in terminal button with a tip of
standard driver, and insert the
cable securely.
For the type of cables, refer
to p. 3-73 , Type of Cable.
For the type of cables, refer
to p. 3-81 , Type of Cables.