Toa N-8000 Series - Manual (Page 339)

3-35
Chapter 3 INSTALLATION & WIRING
8.3.3. If the name label is not printed correctly
The name label created using the SX-2000 Setting Software may not be printed in correct size depending on
the configuration environment of your PC. In such cases, try one of the methods described below.
(1) Preparation by hand
Copy the handwriting label on pages 3-36 and 3-37 to a paper with under 0.2 mm in thickness. After writing
names, cut out the pattern paper aligning it with the cutting guidelines.
(2) Preparation by using a PC or word processor
Prepare and print according to the instructions given in the "Dimensional diagram for printing devices"
shown below. Then cut out to the instructed size. The printing paper should be under 0.2 mm in thickness.
[Dimensional diagram for printing devices]
30
13
13
13
13
13.5
13.5
136
13
x
9
(=117
)
39
110
30
Name label A
Cutting size: 30 x 110 mm
Name label B
Cutting size: 30 x 136 mm