Toa N-8000 Series - Manual (Page 243)

2-132
Chapter 2 FUNCTIONS AND OPERATION
N-8000AL TELEPHONE INTERFACE CONNECTED TELEPHONE
N-8000AL TELEPHONE INTERFACE
CONNECTED TELEPHONE
FUNCTIONS AND OPERATION
1. BASIC USAGE
1.1. Calling from a Telephone (Individual Calls)
Step 1. Lift the handset and press the station number to be called.
The calling station's handset speaker sounds an audible call tone.
When a busy tone is heard, wait till the line becomes free, and you are
automatically connected to the called party.
Step 2. Start conversations when the call tone stops and the called party answers.
Note
When the system is set to "Sequential Response*" and the called station set
to "Automatic Connection Mode*," it is possible to start conversations after a
brief call tone is sounded once. In other settings, the call tone continues to
sound and stops when the called party answers, allowing conversations to
start.
Step 3. To finish conversations, replace the handset.
* Use the supplied N-8000 Setting Software to perform Sequential response and Incoming call mode setting.
(Refer to p. 5-26 .)
Notes
• If the system has been set for call time-out or conversation time-out, the call or conversation automatically
stops after the specified time limit. The specific length of this time-out (in 10-second units between 10 and
990 seconds) is preprogrammed into individual N-8000ALs using the supplied N-8000 Setting Software.
(Refer to p. 5-98 . )
• Conversations are not possible between the N-8000AL-connected telephone and an outside line telephone.
• Conversations are not possible between the N-8000AL-connected telephone and the PBX extension
telephone via the N-8000MI or tie-line connected intercom stations.
• Set the N-8000AL-connected telephone so that it outputs a PB signal. (The N-8000AL does not operate on
DP10 or DP20 signals.)
1 5
Call tone
Telephone