Toa N-8000 Series - Manual (Page 256)

2-145
Chapter 2 FUNCTIONS AND OPERATION
N-8000AL TELEPHONE INTERFACE CONNECTED TELEPHONE
3.1.3. All-call paging
Paging calls can be made simultaneously to all of the pre-programmed zones.
Use the supplied N-8000 Setting Software to set the paging zones. (Refer to p. 5-121 .)
Step 1. Lift the handset, then press the [ ][8] keys, followed by the paging zone number 0 (for all-call paging).
A paging tone is transmitted to all zones.
Note
Enter a zone number with the same digit length (1 − 3 digits) set with the N-8000 Setting Software.
Step 2. Page with the handset.
Note
If the system's paging response mode has been for Zone number designation response (refer to p.
2-32 ), notify the paged party to respond to [0] in the paging message.
Step 3. Replace the handset to terminate the paging.
8 0 0 0
1
3
2
Zone 1
Amplifier
Speakers
No. 100
Zone 192
Amplifier
Speaker
(Zone number with 3-digit length)