Toa N-8000 Series - Manual (Page 182)

2-71
Chapter 2 FUNCTIONS AND OPERATION
MASTER STATION'S FUNCTIONS AND OPERATION
5.8. External Equipment Control
(only when the N-8000MI/8000DI/8000AF/8050DS/8540DS/8640DS/8650DS is used)
External equipment can be controlled by transmitting a one-shot make output signal (or make/break contact
signal) to the contact of the designated Multi-Interface unit, Direct Select unit, or Audio Interface unit, or by
manually causing the station to transmit a one-shot make output signal to the contact of the designated door
station. Remote door lock control can be performed using the one-shot make output, and indication boards can
be controlled using the make/break output.
Note
Use the supplied N-8000 Setting Software to set the one-shot make duration, operation number digits, operation
numbers, and the stations allowed to control external equipment. (Refer to p. 5-35, 5-43, 5-49 , 5-62, 5-67,
5-82, 5-106, 5-110, 5-114, 5-117 .)
Data receiving device Door lock control
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
[Door remote control example using one-shot make output control]
[Hospital waiting status indication board example using the make/break output]
3 0 X X
Contact access No. (2 – 4 digits)
......
Function designation number
[One-shot make output operation]
Press [Function key][3][0], then the access number for the contact corresponding to the external equipment to
be controlled.