Toa N-8000 Series - Manual (Page 245)

2-134
Chapter 2 FUNCTIONS AND OPERATION
N-8000AL TELEPHONE INTERFACE CONNECTED TELEPHONE
2. CONVERSATION FUNCTIONS AND OPERATION
2.1. Calling
2.1.1. Individual calls
• To call a station, lift the handset, then press its station number.
• Conversation can begin when the called party answers and the call tone stops.
• A busy tone indicates that the called party is already engaged on another line.
Connection to the called party will be made as soon as the busy line is freed.
2.1.2. Group calls
• When a station is assigned to group call member station, if the station is called, this station (representative
station) and all member stations are simultaneously called by a continuous call tone regardless of their call
receiving mode settings.
• Even when the representative station is busy, all of the associated member stations within the same group
are called by means of a continuous call tone. This continuous call tone stops when any one of the associated
stations responds to the call.
Notes
• Use the supplied N-8000 Setting Software to perform the group call member station setting.
(Refer to p. 5-99 . )
• The N-8050DS Door Station , N-8540DS/8640DS/8650DS IP Door Station, RS-150/160/170/180/450/460
/470/480 Substation, RS-140/143/144 Switch Panel, and RS-142/442 Switch Board cannot be assigned to the
group call representative station nor member station.
X
X X
Call
Conversation
Station number where
group calls is set
Any key
Continuous call tone Continuous call tone Continuous call tone