Toa N-8000 Series - Manual (Page 336)

3-32
Chapter 3 INSTALLATION & WIRING
8.2. Wall hanging
The N-8610RM can be mounted on a wall using an optional WB-RM200 Wall-Mounting Bracket.
8.2.1 N-8610RM
Step 1. Install the WB-RM200 Wall-Mounting Bracket to
the wall.
In this case, leave the LAN cable out of the notch
in the bracket.
Note
Since there are 2 types of mounting screws
supplied with the WB-RM200 for an electrical
box and for wall. Select ones according to the
mounting method.
For electrical box: Machine screw M3.5 x 20
For wall mounting: Tapping screw 4 x 25
Step 2. Hook the bottom surface of the N-8610RM onto
the WB-RM200.
Step 3. Plug the LAN cable into the N-8610RM's LAN
terminal.
In this case, install the ferrite clamp supplied with
the N-8610RM on the LAN cable as shown below.
60.8
83.5
220.3
28
N-8610RM
WB-RM200 (optional)
[WB-RM200 mounting dimensions]
Unit: mm
LAN
Ferrite clamp
(gray, supplied with N-8610RM)
Wall mounting bracket
WB-RM200 (optional)
N-8610RM
Wall mounting screw
(supplied with the WB-RM200)
LAN cable
Notch
1
2
3
LAN cable
• Install the unit only in a location that can
structurally support the weight of the unit and
the mounting bracket. Doing otherwise may
result in the unit falling down and causing
personal injury and/or property damage.
• Be sure to use 2 screws when mounting the
bracket to the wall.
WARNING