Toa N-8000 Series - Manual (Page 482)

Chapter 5 SYSTEM SETTINGS BY SOFTWARE
IP Station: Remote Mic Settings
5-72
5.7.6. Remote microphone setting (N-8600MS and Ip Remote microphone station only)
Step 1. Click "Remote Mic Settings" tab.
The setting screen below is displayed.
Step 2. Perform Talk key setting.
2-1. Set the Talk key operation mode to either “PTT” or “LOCK.” (N-8610RM only)
PTT: Microphone announcement can be made while the Talk key is held down.
LOCK: Pressing the Talk key once initiates microphone announcement and pressing the key again
terminates the microphone announcement.
2-2. Set the Time-out. (only when the Talk key operation mode is set to “LOCK”) (N-8600MS and N-8610RM)
In case that you forget turning off the microphone switch, select the time to automatically terminate
announcement from the remote microphone.
The time can be selected from 0 to 20 minutes (in 1-minute steps).
Step 3. Perform the chime setting when making zone broadcasts.
(N-8600MS and N-8610RM)
3-1. Select the chime tones at the start and end of the microphone announcement.
Start chime :Select the chime tone at the start of announcement.
End chime :Select the chime tone at the end of announcement.
The chime tone can be selected from “None (no chime tone),” “1 (Ascending 4-note tone),” “2
(Descending 4-note tone),” “3 (2-note tone),” or “4 (gong).”
3-2. Set the chime volume.
Chime volume to be output at the station can be selected.
The setting range is from 0 to -20 dB (in 2 dB steps).
3-3. Set the delay time.
Set the interval after pressing the Talk key until the microphone announcement starts.
When “None” is selected for the Start chime setting, the delay time is time duration before the
microphone announcement starts, and when one other than “None” is selected, it is the time duration
before the chime sounds.
Set the delay time depending on the start-up time of the power amplifier or line selector relay.
The setting value: 0, 0.5, 1.0, 1.5, 2.0, 3.0, 4.0, 5.0, 6.0, 7.0, 8.0, 9.0 (sec.)