Toa N-8000 Series - Manual (Page 358)

3-54
Chapter 3 INSTALLATION & WIRING
Line input
Removable terminal plug
(supplied with the N-8000EX)
Control input
To network
RJ-45 connector
N-8000EX/8010EX Exchange
N-8000EX only
PA Paging amplifier, etc
[General description of connection]
For cables, refer to p. 3-81 .
1. Power supply connection
Connect the supplied power supply cord to AC
Mains or a UPS (Uninterruptible power supply
feeder).
About power supply cord handling
The supplied power supply cord is designed for
exclusive use with the N-8000EX/8010EX.
Never use it with other equipment.
2. Line terminal connection
The line terminals have no polarity.
(Refer to p. 3-83 , Mini-clamp connector connection.)
3. Paging audio output terminal connection
(N-8000ex only)
Paging audio output terminals have no polarity.
(Refer to p. 3-83 , Terminal plug connection.)
[Specification of paging audio output]
0 dB*, 600 , balanced
4. Paging contact output terminal connection
(N-8000ex only)
Paging contact output terminals have no polarity.
(Refer to p. 3-83 , Terminal plug connection.)
[Specification of paging contact output]
No voltage make contact output
Withstand voltage: Max. 24 V DC
Control current: Max. 0.5 A
5. Network connection
Can be connected to a network of 10BASE-
T/100BASE-TX in auto-sensing.
Use a straight through cable of UTP category 5 or
more for this connection.
6. Station connection
The connection method differs depending on types
of stations. (Refer to p. 3-55 , Station and Exchange
connection.)
* 0 dB = 1 V