Toa N-8000 Series - Manual (Page 474)

Chapter 5 SYSTEM SETTINGS BY SOFTWARE
IP Station: Function Settings 1
5-64
(9) Calling station indication
Select either "During call and talk" or "During talk" mode when performing the calling station indication
function.
The table below shows the timing that the Multi interface unit’s, Direct select unit’s, or Audio interface unit’s
contact output is closed.
Calling station indication
IP station operation
Calling
Being called
Call waiting
Talking
Being paged
Receiving scan monitor
During call and talk During talk
Open
Open
Open
Closed
Open
Closed
Closed
Closed
Closed
Closed
Open
Closed
(10) Door station contact output (Ip door station only)
Set the contact output operation mode of the IP door station connected to this exchange.
Select one from "Door remote control," "During call," "During talk," "During call and talk," and "Status
indicator sync."
The table below shows the timing that the IP door station's contact output is closed.
During call
Door station contact output
IP door station operation
Calling
Call waiting
Talking
Being paged
Receiving scan monitor
Door remote
During
call and talk
Door remote
control
During talk
Closed
Closed
Open
Open
Open
Open
Open
Closed
Open
Closed
Closed
Closed
Closed
Open
Closed
Open
Open
Open
Open
Open
Closed
Being called Open Closed Closed Open
Status indicator sync
(N-8640DS/8650DS only)
Closed (lit)
Closed (lit)
Subject to the monitor alert
operation set at the scan-
monitoring station
Closed/open repeated
(flashing)
Sequential Response mode:
Closed (lit)
Selective Response mode:
Closed/open repeated
(flashing)
Closed (lit)