Fluke Biomedical medTester 5000C User Manual
Medtester 5000c biomedical tester operators manual
Advertising
Table of contents
Document Outline
- medTester 5000C Biomedical Tester Operators Manual
- 1. General Information
- SAFETY CONSIDERATIONS
- Introduction
- How to Use This Manual
- Features
- medTester€5000C Optional Modules
- Features
- Optional Accessories
- medTester€5000C Instrument Specifications
- Real Time Clock
- Accessories
- 2. Installation
- 3. Instrument Familiarity
- 4. Manual Tests
- 5. Autosequences
- 6. Customize Your medTester
- How to Customize a Preprogrammed Safety Autosequence
- Customizing a Blank Safety Autosequence
- Test Record Header
- Customizing Your Autosequence Prompts
- Turning Prompts On and Off
- Renaming Prompts
- Pausing
- Test Tag Configuration
- Summary of Stored Records
- Customizing Bar Code Record Data Entry
- Resetting Autosequences to Default Settings
- Printing Your medTester€5000C Configuration
- Customize medTester€5000C Options
- 7. Performance Waves
- 8. Memory
- 9. Defibrillator Module
- Defibrillator Autosequences
- Running Defibrillator Autosequence Tests
- Pretest Device Prompts
- Test Sequence
- APEX Paddle. The APEX paddle test performs two (2) leakage measurements. One with closed ground; the other with open ground. Both measurements are taken under normal polarity and closed neutral conditions. Before these tests execute, this message displays:
- Sternum Paddle. The sternum paddle test is similar to the APEX paddle test. Two (2) leakage measurements are taken, again with closed ground and with open ground. Both measurements are taken under normal polarity and closed neutral conditions. Before these tests execute, this message displays:
- Energy Tests. Energy tests execute in the low range and again in the high range. Low Range is defined as 0-50 joules, and High Range is greater than 50 joules. Defibrillator autosequences are set at the factory so that low range energy step tests execute before high range energy step tests. You can customize your defibrillator testing so that this order is reversed. Prior to executing these tests, this message appears in the medTester€5000C display:
- MAX Energy Test. This test measures the maximum length of time the EUT requires to charge to its maximum energy level. The test also measures the actual energy level. To perform this test do the following:
- Cardioversion Test. If this test is turned on in the custom menu, you can perform the test:
- Posttest Prompts
- Customizing Defibrillator Autosequences
- Customizing IV Pump Tests
- 1. medCheck Module
- 1. Remote Operation
- 1. The Wedge Adapter
- 1. ESU Module
- 1. SPO2 Module
- 1. Transcutaneous Pacemaker (Pacer) Module
- 1. Non-Invasive Blood Pressure (NIBP) Module