Fluke Biomedical medTester 5000C - Manual (Page 218)

medTester 5000C
Operators Manual
14-8
The setup screen prompts the user to set up the ESU for power setting,
mode, and output. Push
F5 READY when the setup is complete. Connect the
ESU device output leads to the ESU analyzer for a generator output
measurement. Activate the ESU output to make a measurement.
The medTester measurement screen gets power readings continuously from
the ESU analyzer and displays them. It continuously compares each reading
with the plus and minus limits programmed for that step. Any readings
outside of the limits are flagged and displayed with a "#" sign. When the ESU
reading stabilizes, press
F5 HOLD to freeze the reading.
The results screen shows the ESU power, Voltage peak to peak in kilovolts,
crest factor (CF), and current. You can accept these readings for this step by
pressing
F5 CONTINUE or press F4 REPEAT if you want to go back to the
measurement screen.
Note
When making generator output measurements with the 454A
and an external load module, ignore the power and peak voltage
readings on the 454A itself. They are not correct because the
454A assumes a different load in this mode. The displayed
medTester readings are correct.
RF Leakage
RF leakage measures the leakage current of the ESU device. The setup screen
shows the load to use, which can be an open load or one of the ESU analyzer
internal loads (RF303
RS
open circuit only). The setup screen prompts the user
to set up the ESU for power setting, mode, and output. Push F5 READY when
the setup is complete.
Connect either the ESU active or dispersive electrode leads to the ESU
analyzer for an RF leakage measurement according to the medTester prompt.
Activate the ESU output to make a measurement.
The medTester measurement screen gets leakage current readings
continuously from the ESU analyzer and displays them. When the ESU
reading stabilizes, press
F5 HOLD to freeze the reading. The results screen
shows the leakage current. You can accept this reading for this step by
pressing
F5 CONTINUE or press F4 REPEAT if you want to go back to the
measurement screen.