Fluke Biomedical medTester 5000C - Manual (Page 172)

medTester 5000C
Operators Manual
11-8
1. OP CODE—This is the operator code for the person doing the
testing. This code can consist of a maximum of three characters
which can be entered from the medTester keyboard. An example
of an operator code could be a person’s initials or employee
number. The previous operator’s code, if any, will appear. If the
current operator has not changed from previous use, press the
ENT key.
2. TYPE—The name of the checklist that corresponds to the
checklist number we have selected appears in this prompt. This
entry can be a maximum of 16 characters.
3. MANF—Enter the name of the device manufacturer, 16
characters maximum.
4. LOC—Type in the location of the device, 16 characters
maximum. The previous location, if any, will appear. If this occurs
and is the desired location, press the
ENT key.
5. MODEL—Enter the device model number, 16 characters
maximum.
6. SERIAL #—Type the device serial number, again 16 characters
maximum.
7. CONTROL #—The selected control number or checklist name
from the IDN file appears for this prompt. You can assign a
control number here for a new device for which this checklist is
written. Enter a control number with a maximum of 16
characters.
8. PHYSICAL INSPECTION—You have two physical inspection
lines, each of which can consist of a maximum of 40 characters.
After entering data for the first prompt, the second prompt
appears.