Fluke Biomedical medTester 5000C - Manual (Page 271)

Biomedical Test System
Transcutaneous Pacemaker (Pacer) Module
16
16-15
Customizing Pacer Autosequences
(For detailed information about customizing autosequences, please refer to
Chapter 6, Customize Your medTester 5000C.)
To begin customizing pacer autosequences, you can view any of your current
ones by entering these menu commands:
1. From the main menu, MENU1 , press the right arrow to access
MENU2.
2. Enter the menu commands:
CUSTOM
F3
AUTOSEQ
F1
3. Press the right arrow, and then press:
PACER
F1
4. From the PACER menu, select:
VIEW
F2
5. Now select the autosequence you want to view.
6. Finally scroll through the steps in the sequence by using your up
and down arrow keys.
Make Your Own Autosequence
You can customize the 5 preprogrammed pacer autosequences or create 5
new ones with the
blank sequences. This section describes the menu steps that
you use to customize, or create, autosequences. Note that each customized
autosequence can include as many as 20 pulse test steps. After you enter the
pulse test values you want, the medTester prompts you for more pulse test
steps, if desired. If you do not want further pulse test steps in your
autosequence, you can press
END .
Note
You can find detailed information about customizing
autosequences in Chapter 6, Customize Your medTester 5000C.