Fluke Biomedical medTester 5000C - Manual (Page 261)

Biomedical Test System
Transcutaneous Pacemaker (Pacer) Module
16
16-5
Pretest Device Prompts
There are eight prompts for information that can appear in the autosequence
test record. After selecting the desired autosequence, the medTester 5000C
prompts you to enter device prompts. If you have some or all prompts turned
off, the autosequence still gives you the brief opportunity to enter device
information at the test’s initiation with the message:
1. OP CODE—This is the operator code for the person doing the
testing. This code can consist of a maximum of three characters
which can be entered from the medTester keyboard. An example
of an operator code could be a person’s initials or employee
number. The previous operator’s code, if any, will appear. If the
current operator has not changed from previous use, press the
ENT key.
2. TYPE—Enter the device name, code, or other descriptor for the
equipment under test. This entry can be a maximum of 16
characters.
3. MANF—Enter the name of the device manufacturer, 16
characters maximum.
4. LOC—Type in the location of the device, 16 characters
maximum. The previous location, if any, will appear. If this occurs
and is the desired location, press the
ENT key.
5. MODEL—Enter the device model number, 16 characters
maximum.
6. SERIAL #—Type the device serial number, again 16 characters
maximum.
7. CONTROL #—Enter a control number with a maximum of 16
characters.
8. PHYSICAL INSPECTION—You have two physical inspection
lines, each of which can consist of a maximum of 40 characters.
After entering data for the first prompt, the second prompt
appears.
Press F5 for all device info prompts