Fluke Biomedical medTester 5000C - Manual (Page 225)

Biomedical Test System
ESU Module
14
14-15
Customizing ESU Autosequences
(For detailed information about customizing autosequences, please refer to
Chapter 6, Customize Your medTester 5000C.)
To begin customizing ESU autosequences, you can view any of your current
ones by entering these menu commands:
1. From the main menu, MENU1 , press the right arrow to access
MENU2.
2. Enter the menu commands:
ESU
F4
AUTOSEQ
F1
CUSTOM
F3
3. From the ESU menu, select:
VIEW
F2
4. Now select the autosequence you want to view.
5. Finally scroll through the steps in the sequence by using your up
and down arrow keys.
Make Your Own Autosequence
You can customize any of the 10 ESU autosequences, either the factory
preprogrammed or the blank ones. This section describes the menu steps
which you use to customize, or create, autosequences. Note that each
customized autosequence can include as many as 30 steps. After you enter the
step parameters you want, the medTester prompts you for more steps, if
desired. If you do not want further steps in your autosequence, you can press
END .
Note
You can find detailed information about customizing
autosequences in Chapter 6, Customize Your medTester 5000C.