Fluke Biomedical medTester 5000C - Manual (Page 39)

Biomedical Test System
Installation
2
2-7
10. To install more than one module, repeat steps seven (7) through
nine (9) for each module which has an installation disk. Install
them in numerical order.
11. If necessary, return to Windows from Command Prompt by
typing:
EXIT<Enter>
at the DOS prompt.
Confirming Module Installation
1. Turn the medTester 5000 power off to reset the microprocessor.
2. Turn the medTester 5000 power on. Check that the startup
message shows the correct instrument serial number and the
correct firmware version number.
3. Push F5 UTIL , then right arrow, then F3 MODULES . At this point,
each press of F5 NEXT will sequentially scroll through each
installed module allowing you to confirm the modules installed in
the medTester 5000.