Customize your medtester, Chapter 6 – Fluke Biomedical medTester 5000C User Manual
Page 93
6-1
Chapter 6
Customize Your medTester
In this chapter you learn how to customize safety autosequences and how
to customize the prompt information that appears before, during, and
after the tests execute.
You can customize the ten standard preprogrammed autosequences and the
five blank safety autosequences. (The five blanks are available for use only
with the medTester 5000C, Waveform/Extended Testing Module.) Refer to
Chapter 5, Autosequences, and the table of safety autosequences. From the table
you see the list of autosequence names and corresponding remote numbers.
For example, the autosequence 10LD X is called 10 Lead External Test with a
remote number of A1. We begin this chapter by customizing A1.
How to Customize a Preprogrammed Safety
Autosequence
To begin learning how to customize safety autosequence A1, 10LD X, view
the steps in the sequence as they exist in the default medTester setup:
1.
From the main menu,
MENU1
, press the right arrow to access
MENU2.
2.
Enter the menu commands:
SAFETY
F1
AUTOSEQ
F1
CUSTOM
F3
3.
From the
SAFETY
menu, select:
VIEW
F2
4.
Now select the safety autosequence you want to view which is:
10LD X
F1