Yaskawa VS-626 MC5 - Manual (Page 128)

6.3 Flux Vector Control
- 25
6.3.2 Setting the Zero-speed Operation Constants
D With flux vector control, operation is possible even when the frequency reference is zero (below the
minimum output frequency).
D Set the operation methods for the minimum output frequency.
J Stopping Method Selection: b1-03
D Set the stopping method used when a stop command is input.
User
Change
during Setting Factory
Valid Access Levels User
Constant
Number
Name
during
Opera-
tion
Setting
Range Unit
Factory
Setting Open Loop
Vector Flux Vector
b1-03 Stopping method selec-
tion 0 to 3 -- 0 Q Q
D Settings
Setting Function
0 Deceleration to stop
1 Coast to stop
2 DC injection braking stop (This setting can’t be made with flux vector control.)
3 Coast to stop with timer (This setting can’t be made with flux vector control.)
J Zero-speed Operation: b1-05 and Minimum Output Frequency: E1-09
D Set the operation method used when the frequency reference is below the minimum output frequency.
User Change
during Setting Factory
Valid Access Levels User
Constant
Number
Name
during
Opera-
tion
Setting
Range Unit
Factory
Setting Open Loop
Vector
Flux Vector
b1-05
Operation selection for
setting of E1-09 or less
0 to 3 -- 0 A
D Settings
Setting Function
0 Operate according to the frequency reference. (E1-09 is invalid.)
1 Interrupt the output. (Coast when the frequency reference is below E1-09.)
2 Operate at E1-09 frequency. (Output the frequency set in E1-09.)
3 Zero-speed operation (Zero reference value when the frequency reference is below E1-09.)
Minimum Output Frequency (FMIN): E1-09
D Set the minimum output frequency according to the requirements of the application.
User
Change
during Setting Factory
Valid Access Levels User
Constant
Number
Name
during
Opera-
tion
Setting
Range Unit
Factory
Setting Open Loop
Vector Flux Vector
E1-09 Min. output frequency 0.0 to 400.0 Hz 0.0 Q A
6