Yaskawa VS-626 MC5 - Manual (Page 185)

7.3 Common Functions
- 47
User
Change
during Setting Factory
Valid Access Levels User
Constant
Number
Name
during
Opera-
tion
Setting
Range Unit
Factory
Setting Open Loop
Vector Flux Vector
H5-01 Station address 0 to 20 -- 1F A A
Baud Rate: H5-02
D Set the baud rate for MEMOBUS communications.
User
Change
during Setting Factory
Valid Access Levels User
Constant
Number
Name
during
Opera-
tion
Setting
Range Unit
Factory
Setting Open Loop
Vector
Flux Vector
H5-02 Communication speed
selection 0 to 3 -- 3 A A
D Settings
Setting Baud Rate
0 1200 bps
1 2400 bps;
2 4800 bps
3 9600 bps
Communication Parity: H5-03
D Set the parity for MEMOBUS communications.
User
Change
during Setting Factory
Valid Access Levels User
Constant
Number
Name
during
Opera-
tion
Setting
Range Unit
Factory
Setting Open Loop
Vector Flux Vector
H5-03
Communication parity
selection
0 to 2 -- 0 A A
D Settings
Setting Function
0 No parity
1 Even parity
2 Odd parity
Stopping Method after Communications Error: H5-04
D Set the stopping method to used after a communications error is detected.
User
Change
during Setting Factory
Valid Access Levels User
Constant
Number
Name
during
Opera-
tion
Setting
Range Unit
Factory
Setting Open Loop
Vector
Flux Vector
H5-04
Stopping method after
communication error
0 to 3 -- 3 A A
D Settings
Setting Function
0 Deceleration to stop (deceleration time:C1-02)
1 Coast to stop
2 Emergency stop (deceleration time:C1-09)
3 Continue operation (display only)
Communications Error Detection: H5-05
D Set whether or not to detect a communications timeout as a communications error.
User
Change
during Setting Factory
Valid Access Levels User
Constant
Number
Name
during
Opera-
tion
Setting
Range Unit
Factory
Setting Open Loop
Vector Flux Vector
H5-05
Communication error
detection selection
0 1 -- 1 A A
D Settings
Setting Function
0 Do not detect as communications error.
1 Detect as communications error.
7