Applied Motion RS-232 - Manual (Page 266)

266 920-0002 Rev. I
2/2013
Host Command Reference
STAC5-S
SVAC3-S
Parameter #1 Optional “Y”, output number, output condition
NOTE: Including/omitting the optional “Y” has no effect on the execution
of the command.
- units Optional “Y”, integer, letter
- range - integer: 1 - 2
- letter: L = Low, H = High
STAC5-Q, STAC5-IP
SVAC3-Q, SVAC3-IP
Parameter #1 Optional “Y”, output number, output condition
NOTE: Including the optional “Y” indicates that the output(s) resides
on the IN/OUT1 connector (DB-15). Omitting the “Y” indicates that the
output(s) resides on the OPT2 connector (DB-25).
- units Optional “Y”, integer, letter
- range - integer for IN/OUT1 connector: Y1- Y2
- integer for OPT2 connector: 1 - 4
- letter: L = Low, H = High
ST-Q, ST-Si, ST-C, ST-IP
SV7-S-SV7-Q, SV7-Si, SV7-C, SV7-IP
Parameter #1 Optional “Y”, output number, output condition
NOTE: Including/omitting the optional “Y” has no effect on the execution
of the command.
- units Optional “Y”, integer, letter
- range - integer: 1 - 4
- letter: L = Low, H = High