Applied Motion RS-232 - Manual (Page 314)

314 920-0002 Rev. I
2/2013
Host Command Reference
Error Message / Indication Explanation Solution
“You have not set the load
inertia in the Motor Settings.
The electronic damping
and anti-resonance will
work better if you set the
load inertia accurately. Do
you want to download your
settings anyway?”
The drive is missing important information
used to properly configure the anti-resonance
features. The motor will run without this
information, but it may not be as smooth
as it otherwise could be. This is generally
acceptable only for initial testing, and should
be addressed before normal operation. Set the load inertia. Depending on the
configuration software used, it is either
possible to enter the actual calculated load
inertia or a best-guess estimate of the inertia
ratio (load : motor). For example, if the load
inertia is five times that of the motor’s rotor,
the ratio would be entered as 5 : 1.
Drive’s LED blinks red and
green
An alarm or fault condition exists. The
display consists of a specific number of red
and green blinks, and will repeat continuously
until resolved.
Fault codes are drive-dependent. Consult
Appendix E and your drive’s hardware
manual for specific information.
Drive’s LED shows solid red
A firmware download was interrupted, and
the drive is unable to boot properly. Cycle power on the drive and repeat the
firmware download process.