Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 1035)

Brocade Network Advisor SAN + IP User Manual 981
53-1002949-01
Adding target disk LUNs for encryption
25
- Fabric
- State
- Thin Provision LUN
- Encryption Mode
- Encrypt Existing Data
- Key ID
• Remove button: Remove s a selected entry from the table.
3. Click Add to launch the Add New Path wizard.
The Select Target Port dialog box displays. (Refer to Figure 416 .)
FIGURE 416 Select Target Port dialog box
The dialog box is used to select a target port when configuring multiple I/O paths to a disk LUN.
The dialog box contains the following information:
• Storage Array : The storage array selected from the LUN view prior to launching the Add
New Path wizard.
• Host: The host selected from the LUN view prior to launching the Add New Path wizard.
• Target Port table: Lists target ports using the following identifiers:
- Target Port
- Target Port Name
- Fabric
- Container Name
4. Select the target port from the Target Port table, then click Next.
The Select Initiator Port dialog box displays. (Refer to Figure 417 .)