Viewing and editing switch encryption properties, Viewing and editing switch encryption properties 2 – Brocade Network Advisor SAN + IP User Manual v12.1.0 User Manual

Page 1076

Advertising
background image

1022

Brocade Network Advisor SAN + IP User Manual

53-1002949-01

Viewing and editing switch encryption properties

25

FIGURE 445

Encryption Targets Disk LUNs dialog box - Time left for auto rekey

Viewing and editing switch encryption properties

To view switch encryption properties, complete the following steps:

1. Select Configure > Encryption from the menu task bar to display the Encryption Center

dialog box. (Refer to

Figure 303

on page 852.)

2. Select a switch or encryption engine from the Encryption Center Devices table, then select

Switch/Engine > Properties from the menu task bar, or right-click a switch or encryption engine
and select Properties.

NOTE

You can also select a group, switch, or engine from the Encryption Center Devices table, then
click the Properties icon.

The Encryption Switch Properties dialog box displays. (Refer to

Figure 446

.)

Advertising