Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 1783)

Brocade Network Advisor SAN + IP User Manual 1741
53-1002949-01
Event action definitions
48
8. The Mark as Special Events check box is unselected by default. Leave it this way if you want
the event action to be added to the Special Event Handling event action category. Refer to
“Special events handling” for more complete information.
9. Click the Collect support save check box to enable SupportSave on the event. The check box is
unselected by default.
10. Select the Deploy CLI Configuration check box and click Configure if you want to deploy a
configuration from CLI Configuration Manager to products if the policy criteria have been met.
You can only deploy a CLI configuration for IP products.
NOTE
If the CLI configuration you chose from CLI Configuration Manager contains a non-IronWare OS
or Network OS product as a target, the configuration will not be deployed to the non-IronWare
OS or Network OS product.
11. You can either select an existing CLI configuration or create a new one and select that
configuration. After selecting a CLI configuration, the name of the CLI configuration is
displayed in the Selected Configuration field.
- Has Parameters - Displays Yes if the CLI configuration has parameters that require values
to be entered before it can be deployed, and displays No if no parameter needs to be
defined.
- The Parameters list lists the parameters that need to be defined in the configuration.
• The Parameter column displays the parameter and its variables in the CLI
configuration.
• The Source column lists the appropriate SNMP attributes for the parameters. Each
attribute contains a specific parameter value, such as an IP address. Select the
attribute you want from the list.
• The Transformation column uses the product IP addresses and MAC addresses listed
in the Address Finder. If the Address Finder list is empty, the product or port will not be
found. From this column, specify what you want Event Processor to do with the value
in the attribute:
Find Device: Find the product with the IP address in the attribute and deploy the CLI
configuration to that product.
Find Port: Find the port on a product with the IP address in the attribute and deploy
the CLI configuration to that port.
Find Intruder MAC: Find the product with the IP address in the attribute that matches
the intruder MAC address and deploy the CLI configuration to that product.
None: Event Processor only reports occurrence of the products.
12. Select the Deploy Product Configuration check box if you want to deploy a payload from the
Configuration Wizard to the products if the policy criteria have been met.
NOTE
If the configuration payload you choose from the Configuration Wizard contains a non-IronWare
OS or Network OS product as a target, the payload will not be deployed to the non-IronWare OS
or Network OS product.
13. From the Target list, select the product (the target source) to which the payload will be
deployed: