Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 1398)

Brocade Network Advisor SAN + IP User Manual 1349
53-1002949-01
VLL manager
37
• Raw: The ingress router does not add a VLAN ID to the packets.
• Tag Mode -
• Tagged: If the endpoint is a tagged port, the device transmits the packet with the specified
VLAN ID and forwards it out the specified interface.
• Untagged: If the endpoint is an untagged port, the device removes any VLAN ID before
transmitting it out the specified interface.
• L2 Status - Layer 2 status (Up or Down).
• Outer VLAN ID - Present if the Tag Mode for the endpoint is Tagged. The service provider
end point tag.
• Inner VLAN ID - Present if the Tag Mode for the endpoint is Tagged. The customer end point
tag.
8. Right click any entry in the table to display the Print pop up menu. Select Print from the menu
to print the table.
Viewing Saved VLL configurations
To view current saved VLL configurations, do the following:
1. Select Configure > MPLS > VLL.
2. Select the Saved Configurations tab ( Figure 587 ).
FIGURE 587 VLL Manager Saved Configurations tab
3. You can use the Name field to filter output by configuration name. You can use an Asterisk (*)
as a wild card character.
4. Click the Get button to begin the search.
Configurations that match the filter criteria display under Saved Configurations, showing the
configuration ID, the configuration name, and the RBAC user name that created the
configuration.