Global server load balancing, In this chapter, Gslb manager – Brocade Network Advisor SAN + IP User Manual v12.1.0 User Manual

Page 1449: Configuration requirements, Chapter 39, Configuration requirements 1, Chapter 39, “global server load balancing

Advertising
background image

Brocade Network Advisor SAN + IP User Manual

1401

53-1002949-01

Chapter

39

Global Server Load Balancing

In this chapter

GSLB Manager. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1401

GSLB policy management. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1403

GSLB site management . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1409

GSLB zone configuration. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1411

Controller configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1415

GSLB Manager

The Global Server Load Balancing (GSLB) Manager allows you to configure GSLB policies for a
ServerIron ADX product. The ServerIron ADX product on which the GSLB protocol is enabled serves
as a proxy to the Domain Name System (DNS) servers and evaluates the IP addresses in the DNS
replies from the DNS server for which the ServerIron ADX product is a proxy. Based on the results of
the evaluation, the GSLB ServerIron ADX product can change the order of the addresses in the
reply so that the “best” host address for the client is on top.

The GSLB Manager feature is supported for ADP products (ServerIron version 09.0 and later and
ADX version 12.0 or later) only. For more information on GSLB, refer to the ServerIron manuals.

Configuration requirements

Before using the GSLB Manager, confirm the following requirements:

The GSLB Manager privilege is in your Management application user account or role.

The ServerIron ADX products to which the policies, sites, and zones will be deployed are listed
in the Network Object Manager tree. If they are not, make sure they are on the network that is
being managed by the Management application. Then run discovery or add the ServerIron ADX
products to the Management application using Network Object Manager.

Advertising