Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 1143)

1090 Brocade Network Advisor SAN + IP User Manual
53-1002949-01
Zoning administration
26
Finding a member in one or more zones
Use this procedure to locate all instances of a member in the Zones list on the Zone DB tab.
1. Select Configure > Zoning > Fabric.
For LSAN zones, select Configure > Zoning > LSAN Zoning (Device Sharing).
The Zoning dialog box displays.
2. Click the Zone DB tab if that tab is not automatically displayed.
3. Select a fabric from the Zoning Scope list.
This identifies the target entity for all subsequent zoning actions and displays the zoning
database for the selected entity.
4. If you want to show all fabrics discovered in the Potential Members list, right-click in the
Potential Members list and select Display All.
5. Select the devices or ports you want to find in the Potential Members list.
6. Click Find > between the Potential Members list and the Zones list.
If the member is found, all instances of the zone member found are highlighted in the Zones
list.
Finding a zone member in the potential member list
Use this procedure to locate a zone member in the Potential Members list on the Zone DB tab.
1. Select Configure > Zoning > Fabric.
The Zoning dialog box displays.
2. Click the Zone DB tab if that tab is not automatically displayed.
3. Select a fabric from the Zoning Scope list.
This identifies the target entity for all subsequent zoning actions and displays the zoning
database for the selected entity.
4. Select the zone member in the Zones list that you want to find in the Potential Members list.
(Press SHIFT or CTRL and click each zone member to select more than one zone member.)
5. Click Find < between the Potential Members list and the Zones list.
If the member is found, it is highlighted in the Potential Members list.
Finding zones in a zone configuration
Use this procedure to locate all instances of a zone in the Zone Configurations list on the Zone DB
tab.
1. Select Configure > Zoning > Fabric.
The Zoning dialog box displays.
2. Click the Zone DB tab if that tab is not automatically displayed.