Creating a service – Brocade Network Advisor SAN + IP User Manual v12.1.0 User Manual
Page 859
Brocade Network Advisor SAN + IP User Manual
803
53-1002949-01
Layer 3 access control list policy
22
FIGURE 285
Service dialog box, Services tab
2. Review the List of Services table:
•
Name — The service name.
•
Protocol — Whether the service uses the TCP or UDP protocol.
•
Port — The port number.
•
User-defined — Whether the service is user-defined or not.
3. Click Close on the Network dialog box.
To finish configuring the advanced settings, refer to
“Configuring L3 ACL advanced settings”
Creating a service
You can access the Service dialog box when configuring an extended L3 ACL device configuration.
To configure an extended L3 ACL, refer to one of the following procedures:
•
“Creating an extended L3 ACL configuration”
•
“Editing an extended L3 ACL configuration”
•
“Copying an extended L3 ACL configuration”
•
“Creating an extended L3 ACL configuration”
•
“Editing an IPv6 L3 ACL configuration”
•
“Copying an IPv6 L3 ACL configuration”
To create a service, complete the following steps.
1. Click the Services tab.
2. Click Add.
The Add Service dialog box displays.